ENGINE RUN 9M-MMV 13/02/2012

ENGINE RUN 9M-MMV 13/02/2012

1.POWER ON
2.BOOSTER PUMP AFT TANK NO 1 ON
3.ANTI-CO LOGHT ON
4.EMDP OFF
5.PULL ALL THE CB
-VOICE RECORDER
-WHEATER RADAR

1.ON VHF MIC SELECTOR-CONTACT CONTROL TOWER
2.ON APU BLEED,L PACK
3.PERFORM CHECKLIST PRE-RUN ENGINE
4.EFIS BITE TEST
PED DISPLAY N2 106.0 EGT 930 N1 105.0 FF 50.0
SED OIL PRESS MIN,OIL TEMP MAX,50 50,50

1.SET ALTIMETER 0.040 71-00-00
2.REFER MPA (MAXIMUM POWER ASSURANCE) 71-00-00
FOR ENGINE MAX RATING TO MONITOR

ENGINE START
1.OFF ALL PACK VALVE
2.ON ALL BOOSTER PUMP
3.APU BLEED ON
4.SELECT START VALVE TO GROUND
5.SEE N2 UNTIL 25,,CUTOFF-----IDLE
6.START NO 1 ENGINE..
7.AFTER THAT,START NO 2 ENGINE

AT MPA,SEE FOR 28 DEG AMBIENT

ENGINE IDLE
PED                                                      SED
ENGINE 1       ENGINE 2                    28    OIL PRESS    28
20.8                 21.5                               80    OIL TEMP     80
634                  584                                0.5       VIB            0.5
62.6                 61.7
0.38                 0.36

ENGINE FULL POWER TEST (TARGET 86.8 N2)

PED
ENGINE 1      ENGINE 2
86.8
780
96.5

RUN SUCCESS (4 MINUTES)..SECOND ROUND (1 MINUTE)

PERFORM BLEED CHECK

1.APU BLEED OFF
2.BOTH PACK-ON
2.MONITOR THE GAUGE LEFT N RIGHT L 41,R 51